|
|
|
|
|
|
|
|
WEIR SPM FRAC PUMP FLUID END
|
|
JinGao Petro offers SPM Frac Pump Fluid end and Parts replacement serivces
Plunger and valve&seat Interchangeable with the following models:
SPM:TWS600,TWS900, TWS1000,TWS2250,QWS2500
Gardner Denver: GD2500,TEE-165
Halliburton: HT400
Serva: TPA-400,TPA-600,TPB-600
Plunger: hard surface-coated or flame-sprayed, long service life. Plungers are used to pull fluid into the fluid end through the suction valve and push it out through the discharge valve. They do it by retracting from the fluid end to create volume in the fluid end chamber and then extending back into the fluid end chamber to displace volume and push the fluid out.
Pump
Manufacturer Pump Model Plunger Size Plunger Part No. Pump
Manufacturer Pump Model Plunger Size
Weir SPM TWS600 2.50″ 3P104740 Gardner Denver GD2250 4.00″
2.75″ 3P101733 4.50″
3.00″ 3P100325 5.00″
3.50″ 3P100293 J-mac TWS2250 4.00″
4.00″ 3P100813 4.50″
4.50″ 3P100181 QWS2510 4.00″
TWS1800/2000 3.75″ 3P103887 4.50″
4.00″ 3P100339 Halliburton HT-400 4.00″
4.50″ 3P100654 4.50″
5.00″ 3P100233 Gardner Denver XOPI1300 AWS 4.00″
5.50″ 3P107060 (OPI) EOPI1800AWS 4.50″
5.75″ 3P107061 OPI, OMEGA OPI1300/1800 AWS 5.00″
6.00″ 3P107062
6.50″ 3P100258
TWS2250 4.00″ 3P100339
4.50″ 3P100654
5.00″ 3P100233
5.50″ 3P100136
5.75″ 3P107061
6.00″ 3P107062
6.50″ 3P100258
QWS-2000-2500 3.75″ 3P103887
4.00″ 3P100339
4.50″ 3P100654
5.00″ 3P100233
5.50″ 3P107060
5.75″ 3P107061
6.00″ 3P107062
6.50″ 3P100258
Valve & Seat: forged alloy construction, deep carburized surface, greater fluid flow and easy valve maintenance. Valves are used to direct the flow through the fluid end and separate the suction side of the pump from the discharge side. As the plunger is pulled back the pressure in the fluid end drops causing the discharge valve to pull harder onto the discharge valve seat and also causes the suction valve to lift off its seat.
|
|
|
|
|
|
|
|
|
|
